Title reads like at ad, but this is a new way to reach energy independence. I actually have a small EcoFlow device and it’s pretty good for the price.

I hope this tech can be made available in the US soon.

  • Clasm@ttrpg.network
    link
    fedilink
    English
    arrow-up
    2
    ·
    4 months ago

    Yeah, non-USA for this atm, as much fun as it would be to plug such a system into an apartment.

    I believe that the US requires that a direct-feed system has to plug into a physical kill switch setup to prevent back-feed of power during an outage.

    Still pretty neat, though!

      • MinorLaceration@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        4 months ago

        They don’t follow the grid frequency because the EU or US regulations require it, they follow the grid frequency because physics demands it.

            • Pretzilla@lemmy.world
              link
              fedilink
              English
              arrow-up
              1
              ·
              edit-2
              4 months ago

              I think I get that, thanks. So an Island grid is less stable and could cause itself damage if two microinverters say are trying to sync up to each other vs a beefy, stable main grid?

              So how does a backup battery system work when islanded? Typically also at 52Hz?

              Or can it go into a 60Hz beefy mode?

              It would be nice to get all the little island solar inverters working when the grid goes down!

              • skyspydude1@lemmy.world
                link
                fedilink
                English
                arrow-up
                0
                ·
                4 months ago

                I’m guessing the commenter above is in the EU and operating at 50Hz normally, so running at 60Hz wouldn’t be a great idea. A backup battery and such operate in the same way when islanding.

                  • skyspydude1@lemmy.world
                    link
                    fedilink
                    English
                    arrow-up
                    1
                    ·
                    4 months ago

                    IIRC some inverters are able to sync up with alternative power sources, but the documentation is extremely limited and seems to be reserved mostly for large-scale systems. I know my Solaredge system has slowly been implementing using both at the same time, but the documentation is pretty unclear as to how this works. I know at the very least it’ll allow you to use a 2-wire start to kick a standalone generator on when the batteries are low, but don’t know much else about how it’s currently set up

      • Clasm@ttrpg.network
        link
        fedilink
        English
        arrow-up
        1
        ·
        4 months ago

        That’s great, but it doesn’t matter unless it has the physical cutoff that’s required to bring that kind of system up to the current electrical code for such a system.

        • luckystarr@feddit.de
          link
          fedilink
          English
          arrow-up
          1
          ·
          4 months ago

          Physical shutoff via relays is required by the standard. We’ve just been through a scandal where a manufacturer skimped out on putting them in and had to recall the devices.

    • farcaster@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      4 months ago

      According to the article this system also detects power outages and shuts off when they happen. Just like full-scale solar power systems. But yeah, no physical kill switch.

    • mal3oon@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      arrow-down
      1
      ·
      4 months ago

      I hate technologies that limit cannot use with another manufacturer’s battery". Smells monopoly.