Rocket.chat could be an option
Got a split keyboard (ergodox ez) just to notice that all the special keys are very tough to reach and there are no F-keys. All in all not such a great experience. The split part is good though if you type a loooot anf if you have wrist rests.
Did you measure that? Would be great if it was only fractions of a mm.
Would a larger inner diameter not cause the transmission of movement to be less direct due to bending and coiling inside the tube? This is probably mostly an issue in bowden systems
Uh, I must admit I don’t know about that bro method.
There are some serious differences between a badly made loaf and a well done one though. You never stop learning. But yeah, it’s easy to get something passable.
Apparently it did. I only remember the three button version. Anyways, it was before its time. Now with the custom keyboard craze, it seems to fit perfectly. Then again, if I wait another 2 years, the chinese will provide me the thing for a quarter of the price.
Interesting. I might have a look. Actually I don’t have a problem with speed though. I spend most time not dealing with pip and pip-tools but reading docs, programming and fixing the weirdest bugs
Pip-tools!
How much does a display cost? Reminds me of that keyboard that never materialised line 20 years ago by ArtLebedev.
Sorry, I completely didn’t read all of your comment. You’re right about resistance but then again the filament won’t need to touch the enclosing coil at a large surface. In the usual bowden tubes, you have a lot of contact surface between tube and filament but this would not need to be the case in the drying coil. In the end it would all depend on the application. I’m not interested in very high speed printing (yet) because my machines are all pretty slow :).
You “just” need a longer distance inside the drying chamber. This could be achieved by coiling up the space where the filament travels through and guide hot and dry air through that space, ideally from the outlet towards the inlet. That air could maybe be pulled from the hotend cooler.
Argh finally someone tries the obvious solution. I was already considering it but was demotivated since it seemed so obvious and nobody seemed to have done it before.
This device could also probably be printed in PLA. I can’t wait until I get my lab power supply so I can give this a try with a wire coil heater.
Edit: you could even mount some PTFE tubing mounted below a heated bed and pass air through it. That way you could potentially get away without a heating element and re-use some power usually lost.
Full agree!! I use the dev version too!
The 1.0 release is around the corner. It’s only a matter of a few weeks. It has the toponaming problem fixed and a built in assembly toolbox!
I’m interested to hear how it turns out!
To get a wider space than between words. Computers usually adjust spaces automatically so you don’t need to do it yourself.
Not true about xmpp in general. There are modern clients out there.
What’s your problem with xmpp?
What should notifications be like instead?