Hasn’t threads not even turned on activitypub support yet?

But of course, such based individuals will never be billionaires. Specifically because their basedness precludes them from being psychopathic enough to commit the kind of cutthroat, violent exploitation of tens of thousands of workers’ labor inherently necessary to amass such wealth.

I hope to retire from living at the age of young, hopefully

Step 1: download all Dropbox files Step 2: delete Dropbox account

The fact that you have to opt out of such an invasive overreach of privacy is asinine and should not be supported.

your mother started the load over! AYO!

Or a stock market! Or a 401k investment manager, or…

I’ve almost always used PrusaSlicer just because the only printers I had access to were mk3s+.

I’ve started playing with Cura though because A. i wanted some more complex prints that PrusaSlicer struggled to support, and B. We also got some creality cr-30’s functional at my college again. So far I still feel Prusa is easier but that’s likely just familiarity.

Maybe I am, maybe I ain’t…

Damn I wish I had money

Mmm clothes smelling like dirt 🥰🥰

Yeh but then I just dismiss the timer and it is gone from my brain before my phone is even set back on the table

Hmm. If the common wear items are commodity parts I’d probably be okay with it.

It being a high gear ratio direct drive is a huge plus too. I like my TPU.

I’ll add it to the consideration list for next year’s graduation present to myself.

The secret is to gamble with other people’s money…

How much did it run you all in?

I’m a little iffy on jumping on the Chinese supplier train just because I worry about longer term parts and software support. Id rather support a based company like Prusa, except Prusa just isnt keeping up with everyone else in the features/capabilities department… But if the Chinese supplier’s quality passes, it’s hard to argue against.

Dobbery

Do I, though??

I prefer One Giant Onion myself

The design-model-to-print pipeline is really what I enjoy the most too. Very nice design work!

Feels like a lot of people get into printing but then just print existing models from online- which is valid, but missing out on a HUGE opportunity that is really what makes 3d printing useful.

What in the fuck was that kanye??

I told you to do some shit for the kids!

Sure, but on these fully DC printers all the power control hardware is integrated into the main board and supplied from a single main power rail. You’d have to basically build a separate power control board with that would allow you to isolate those MOSFET’s on their own power rail and then jump the PWM control signal over to it from the main board. Decent amount of electronics knowledge and skill required to pull that off.